User's Manual

E-17
Enhancing your system
The connection cord is not included. 3urchase a coPPer-
ciall\ availaEle cord as shown Eelow.
Audio caEle not supplied
3ortaEle audio
pla\er etc.
■ Listening to the playback sounds of
portable audio player, etc.
1 Use a connection cord to connect the portaEle audio
pla\er etc. to the AU'IO IN MacN.
2 3ress the ONSTAN'%< Eutton to turn the power on.
3 3ress the AU'IO/INE IN3UT Eutton rePote con-
trol or FUN&TION Eutton repeatedl\ Pain unit to
select AU'IO IN function.
4 3la\ the connected eTuipPent. If voluPe level of the
connected device is too high sound distortion Pa\
occur. Should this happen adMust the voluPe of the
connected device.
Note:
To prevent noise interference place the unit awa\ froP
the television.
■ Headphones
● 'o not set the voluPe on to PaxiPuP at switch on.
Excessive sound pressure froP earphones and head-
phones can cause hearing loss.
● %efore plugging in or unplugging the headphone re-
duce the voluPe.
● %e sure \our headphone has a 18” . PP diaPeter
plug and iPpedance Eetween 16 and  ohPs. The
recoPPended iPpedance is  ohPs.
● 3lugging in the headphone disconnects the speaNers au-
toPaticall\.
Troubleshooting chart
If soPething is wrong with this product checN the following
Eefore calling \our authori]ed S+AR3 dealer or service
center.
■ General
Symptom Possible cause
● The clocN is not set to
the correct tiPe.
● A power failure occurred.
Reset the clocN. Refer
page 1
● When a Eutton is
pressed the unit does
not respond.
● Set the unit to the power
standE\ Pode and then
turn it EacN on.
● If the unit still
Palfunctions reset it.
Refer page 1
● No sound is heard. ● The voluPe level set to
“Min”.
● The headphones are not
connected.
● The speaNer wires are not
connected.
● The unit is too far froP the
Bluetooth stereo audio
source device.
● The unit is not paired with
the Bluetooth stereo audio
source device.
■ Remote control
Symptom Possible cause
● The rePote control
does not operate.
● The A& power cord of the
unit is not plugged in.
● The Eatter\ polarit\ is
wrong.
● The Eatter\ is dead.
● The distance or angle is
incorrect.
● The rePote control sensor
receives strong light.
■ Bluetooth
Symptom Possible cause
● No sound is heard. ● The unit is too far froP the
Bluetooth stereo audio
source device.
● The unit is not paired with
the Bluetooth stereo audio
source device.
● Bluetooth sound
is interrupted or
distorted.
● The unit is too near to
a device that generates
electroPagnetic radiation.
● There is an oEstacle
Eetween the unit and the
Bluetooth stereo audio
source device.