User's Manual

E-6
OPERATION
E-5
OPERATION
USING THE FM RADIO
- Press “FUNCTION” key repeatedly until display shows FM.
- To improve radio reception, extend the telescopic antenna found at the rear of the unit.
- After tuning into a desired station, use “FM MODE” key to select (MONO/STEREO) mode.
- In some case, when the reception is poor, we recommend to use “MONO” mode for better clarity.
Manual Frequency Adjustment (Scan Mode)
- Press & immediately release “TUNE +” or “TUNE -” key to manually adjust the radio frequency
1 step at a time.
- When the desired station is reached, it can be saved into one of the “MEMORY” positions.
(See “Radio Memory” section for further details).
Automatic Frequency Adjustment (Seek Mode)
- Press & Hold (For 2 seconds) key to seek the next available radio station
frequency.
- When the desired station is reached, it can be saved into one of the “MEMORY” positions.
(See “Radio Memory” section for further details).
“TUNE +” or “TUNE -”
Radio Memory
- After tuning into a desired station, it can be stored into one of the 20 available memory positions.
- Short Press “PROG.” key to go to memory tuning mode. Display will show “P-01” (FLASHING).
- Press & release “MEM +” or "MEM -" key to choose the desired memory storage
position you would like to store into (P-01 to P-20).
- Short Press “PROG.” key again to confirm selection. The display will stop flashing.
- To erase a saved radio station, simply replace it with a new station in same memory position.
Recalling a saved memory station
- Short press “MEM+” key to find a saved memory position. or "MEM -"
Using Audio Line-in Connection (AUX-input)
- This unit comes with an Audio Line-input jack(Labelled Aux-Input), allowing you to connect a
device using an Auxillary cable.
- Connect your external device to this unit using a standard stereo headphone (3.5mm to 3.5mm)
cable.
- Press “FUNCTION” key repeatedly until display shows “AUX”.
- Switch on your external device & activate playback on it.
- Playback of external device will start momentarily. Adjust the volume control of the main unit
and your external device to the desired level.
- Playback control can be done only through your external device.
- Remember to switch off the unit when you finish using the external device.
- - -
Power Supply : ............... Rechargeable Lithium 3.7V/ 4000mAh X 1 PC. (Built-in)
AC-Charger Output : ...... DC 5V 1A
Recharge Power : .......... USB 5V 1A
Radio Frequency : ......... FM 87.5 - 108 MHz
Speakers : ......................3.5"x2
SPECIFICATIONS
USB PORT (For MP3 PLAYBACK)
KEY
NEXT
FUNCTION
BACK
For USB thumb drive MP3 Playback
Skip to next song
+ 10
FOLDER +/ FOLDER -
PLAY/ PAUSE
P-MODE
Press repeatedly until “USB” is displayed
Skips 10 tracks forward during MP3 playback
Press to choose Folder location on your USB
(Not usable in RANDOM play mode)
Skip to previous song
NOTE:
It takes time to “Open & Verify” a large USB-Drive, and count all the song files.
If there are many files, it can take up to 60 seconds for this process.
IMPORTANT: REMOVAL OF USB DRIVES
Never remove USB drives from the unit during playback.
Always STOP playback, then press “FUNCTION” key to switch to another mode (FM/BT/AUX)
before removing your USB memory to prevent damage to your song files and memory
device itself.
- The following chart shows how to use USB mode:
Start playback or pause playback
STOP
Stop playback
NORMAL
PLAY
REPEAT
1
REPEAT
FOLDER
REPEAT
ALL
RANDOM
PLAY
- After inserting a USB memory drive to the USB MP3 SOCKET (8) , within 1 minute the unit will
momentarily display the total number of MP3 songs it has found, and then immediately start
playing the first song (# 001).
USB POWER BANK (charging port for external devices)
This unit is equipped with a DC 5V USB charging port (6). To utilize this feature, simply connect
the device you would like to charge (eg. Smartphone or Tablet) to a suitable USB cable and plug
it into the USB charging port.
Press & Hold the "Power" Key for 3 seconds to start the USB-Charging
(Red Charging LED will Flash slowly).
The Charging LED will automatically switch off when the device is fully charged,
or when no device is connected.
NOTE:
- Only charge external USB Devices if internal battery exceed 30% capacity.
- Charging function is not available in FM Mode.
- Some devices may not be recharged properly.
- The USB charging port (6) is designed for charging only.
It does not allow data communications.
- - -
Press & Hold the "Power Key"
for 3 seconds to start
the USB-Charging.
(Red Charging LED will Flash slowly)