User manual
52.0 Megapixel H.264 Network IP Camera User Manual
SECTION 2: INSTALLATION AND SETUP
Your IP camera is pre-congured with a static IP address, subnet mask, and gateway setting:
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Gateway: 192.168.0.1
Usually these settings are changed during installation to ones more compliant with the network
conguration.
When initially connecting a camera to your network, there is a possibility that the camera’s pre-
congured IP address may already be in use on the network. Check your network before attaching your
camera to ensure there is not a conict with another device. Also, install and recongure additional
cameras one at a time to avoid conicts with other cameras or devices.
Use the following procedure to determine a compliant IP address to assign to your camera. If connecting
your camera to a large enterprise network, consult with your network administrator before attaching
the camera to the LAN for network settings to ensure that your camera won’t initially conict with other
devices. Your network administrator should also setup WAN (Internet) access to the camera.
If you encounter a problem and need to contact Supercircuits Support, rst complete the chart in step 1
about your Computer (PC) and camera network settings, if possible. Support will need this information to
provide assistance.
1. At a PC attached to the same LAN that will be shared with your camera, determine the IP address,
subnet mask, and default gateway of your PC and record it in Table 1. To nd this information, do
the following at the Windows desktop:
a. Hold down the Windows key and press r to open the Run dialog box.
b. Type cmd in the entry eld and click OK to open the DOS command window.