Specifications
61IP Camera and Encoder Software Manual
SECTION 3: SETUP CONFIGURATION
Fields in the table below the camera image are dened as:
Use: To disable or enable a zone, click the checkbox.
Sensitivity and ObjectSize: This data shows the relative settings for Sensitivity and ObjectSize.
Adjustments are made using sliders on the right side of the table.
Location: The bounds (pixel location) of each detection zone are shown.
Sensitivity and ObjectSize (adjustment): Sliders are used to adjust for sensitivity and object size. In
the screen shown above, meta data is graphed for Zone 6 on the right side of the screen. The object size
threshold is represented by the horizontal bar at 28.
About Sensitivity
Each motion detection zone is divided into multiple squares called Macro blocks, 16 x 16 pixels
each. The Sensitivity adjustment made to the zone is applied to every macro block in the zone. To
decrease the Sensitivity of a zone, increase the Sensitivity number by dragging the slider to the
right. Similarly, increase the Sensitivity by dragging the slider to the left to decrease the Sensitivity
number.
About ObjectSize
The OjectSize number indicates the proportion of Macro blocks that exceeded the congured
Sensitivity. To decrease the zone Sensitivity through ObjectSize, drag the ObjectSize slider to the
right to increase the number (of Macro blocks). Similarly, increase the sensitivity by dragging the
slider to the left.
Conguring Motion Detect zones
To congure the motion detect zone:
1. Check the box in the Use column to enable a zone for motion detection. The device supports up to
8 zones. To disable a zone, uncheck the box in the Use eld.
2. Adjust the sensitivity and object size of selected zone by dragging the sliders left or right.
3. Click the Apply button on the right side of the table for the zone you are adjusting.
4. After completing the conguration setup for each zone using step 1~3, select Motion Enable to
enable the motion detection for all zones enabled.
5. Click Apply.