Specifications

47IP Camera and Encoder Software Manual
SECTION 3: SETUP CONFIGURATION
Steps for manual recording
Step 1. Enable recording
Enable Recorder: Select this option to record data. If it is not selected, data is not recorded, even if you
click START to record.
Enable automatic recording shortly after mounting storage device: Check this option if you want
the recorder start recording when a storage device, such as an SD card or USB Memory Stick, is
attached. If this option is not selected, recording starts only when it is manually started.
Step 2. Selecting the recording storage
Select either SD Card or USB Memory Stick as the storage device.
Step 3. Recycling options
Choose one of the options below when the storage is at capacity:
• Stop recording: Stops recording and keep the recorded data.
• Delete les and recycle (oldest rst): Replace old les with newly created les.
Step 4. Enter a lename prex
Enter a lename prex for the stored video les. The prex is appended with a timestamp in the format:
“_YYYYMMDD_hhmmss.avi”.
Step 5. Primary recording settings – Rule of segmentation
• Do not segment: Select this option if you want to record data as one le.
• Every ___ megabyte(s): If you select this option, enter the size in MB for each segment.
• Every ___ minute(s): If you select this option, enter the number of minutes for each segment.
Step 6. Primary recording settings – Stream Source
First stream: Choose primary recording source from the 1st stream. Both streams cannot be recorded
at the same time.
Second stream: Choose primary recording source from the 2nd stream. Both streams cannot be
recorded at the same time.
None: If this option is checked, the device will not record either stream.