Specifications

39IP Camera and Encoder Software Manual
SECTION 3: SETUP CONFIGURATION
4. Click Apply to save and use the current settings, or click Reset to return to the previous settings.
5. Disconnect the Ethernet cable from the device. Unplugging the Ethernet cable causes the device to
use the wireless network.
6. Wait about 40 seconds for the device to switch to wireless mode.
NOTE
The time to switch between wired and wireless modes may be extended by network conditions.
NOTE
When rebooting a device in wireless mode, the boot time may last 4~5 minutes.
NOTE
If a wireless LAN does not connect normally, verify that the wireless LAN adapter is installed
properly. Click the ‘Refresh Network List’ button and search again for network devices.
7. Click the Update Status button at the bottom of the screen to display the Wireless Network Link
Status.
3.5.7 RTSP/RTP
For Real Time Streaming Protocol/Real-time Transport Protocol (RTSP/RTP) settings, go to SETUP >
System Options > RTSP/RTP