Specifications
36
www.sc-black.com
SECTION 3: SETUP CONFIGURATION
2. Click Refresh USB/SD Device List. If the storage device is not listed, wait for a few seconds and
click Refresh repeatedly until it is recognized.
3. Click a device in the list to highlight it. Verify that the Device Storage Information shown is correct.
4. Click Select Record Device to begin using the device for data storage. To clear all data on the
device, or to format the device so that it is compatible with the encoder, click Format.
NOTE
If the total capacity and free space are not shown, refresh the device list. If the Free Space
information is not shown correctly, format your storage device and click Refresh.. again.
5. After completing the steps above, go to the System Options > AVI File Recorder to setup
recording options.
6. To remove the storage device from the camera or encoder, return to the USB/SC Storage window
and click Eject.
Format: Format causes the storage device to be reformatted. After formatting, data previously stored on
the device may be unrecoverable. To format the storage device, select the device, click Format, and then
click Apply.
Ejecting the disk: To remove the storage device safely, click Eject. When the ejecting process is
complete, you can disconnect the device.
3.5.6 USB Wireless LAN
To use the USB Wireless LAN feature, a USB wireless adapter must be installed on the camera. The
adapter is optional and usable only with some products. It is not included with the basic product.
NOTE
This USB Wireless window shown below is based on the H.264 video encoder. If you are
conguring a different device, see Section 5.
To setup the USB Wireless LAN settings, go to SETUP > System Options > USB Wireless LAN