Installation guide

1
www.digiop.com
BLK-IPS102M_CQ
5/27/11
Your camera can be powered locally with a 12 V DC adapter, or across the LAN (PoE). If using the power
adapter, attach the DC jack adapter cable to the DC 12V power adapter terminals on the back of the camera.
Connect the red wire of the adapter cable to the + terminal, and the black (or white) wire to the - terminal.
DO NOT apply power to the camera at this time.
DC Jack
Adapter
Cable
Step 3. Install IPAdmin Tool
The IPAdminTool is a utility for conguring the network settings of your Digiop Black cameras and installing
new rmware. It can be loaded on a Microsoft Windows XP, Vista or Windows 7 operating system. At a
computer on the same LAN (subnet) where your cameras will be installed, do the following:
1. Insert the CD mini disk provided with your camera into your computer’s CD ROM drive and open the
CD in a Windows Explorer window.
2. Find the IPAdminTool directory on the CD.
3. Copy the IPAdminTool directory with its contents to your computer hard drive.
Step 4. Configure the network settings of you camera
When your IP camera is attached to a network and initially powered on, it attempts acquire compatible
network settings from a DHCP server. If it cannot nd a DHCP server, it congures itself with the following
static (xed) settings, which may or may not be compatible with other devices on the network.
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Gateway: 192.168.0.1
Your camera must be congured with static network settings that are compatible with the LAN. If your
LAN has a DHCP server, use the following sub-step. Otherwise, use the sub-step procedure below for LANs
without DHCP.
Installing cameras on LANs with DHCP
1. Connect your camera to the LAN, then power on the camera.
2. Open the IPAdminTool directory on your computer, then double click the le IPAdminTool.exe to
start the application. When the IPAdmin Tool starts, it will discover all the IP devices it supports that
exist on the network. The discovery process may take a few minutes.
Review the list of IP devices found by IPAdmin Tool. You can identify your camera by the MAC
address. If the camera was not found, click the Refresh button every minute until your camera
appears in the list.
3. After nding your camera, right click the entry, then select IP Address from the drop-down list. An
IP Setup window will open.
Continue 
2.0 Megapixel
H.264 Network IP Camera
Quick Installation Guide
This document guides you through the basic steps to install and congure your Digiop® Black BLK-IPS102M
IP camera. For detailed instructions, refer to the User Manual.
Find the camera’s MAC address on the product label and enter it here: __________________
Step 1. Install the camera
Install the camera mounting bracket using the instructions provided with the bracket.
Attach the adapter for mounting the camera to side with the label or to the opposite side with the four
screws provided.
Mounting
adapter
Remove the protective cap covering the camera CCD.
Attach the lens assembly to the camera by screwing it clockwise onto the camera until it is fully seated. The
lens may require a mounting ring adapter to t onto the camera.
Tighten the lens set screw with the hex wrench provided.
Attach the camera to the mounting bracket.
Connections
Connections to the camera for audio in and out (microphone and speaker), DI sensor, alarm, and RS-485
control are made through a 9-pin terminal block. Plug the terminal block into the mating connector on the
camera.
Attach peripheral devices to the terminal block as needed. For detailed interface specications, refer to the
User Manual.
Step 2. Connect the camera to the LAN
Attach the network LAN cable to the Ethernet connector on the camera backpanel.