Owner's manual

15461 Slover Ave., Fontana, CA 92337 - Phone: [phone] - Fax: [phone] - www.sbfilters.com
Installation Instructions (continued)
10. Attach the S&B Filter Adapter (I) to the
S&B Air box (G), secure using the 5/16 SS
Screws (H) provided.
14. Slide the S&B Hump Adapter (L) over
the MAF sensor’s flange and secure using a #
60 Hose Clamp (J).
11. Place the S&B Air Box assembly into the
vehicle, align the 4 holes with the OE
mounting locations and secure using either
the OE bolts or the supplied M6 allen head
screws (K) and SS washers (R).
15. Slide the S&B Throttle Body Adapter (O)
over the S&B Tube (M) along with the # 72
Hose Clamp (N), do not tighten at this step.
12. Slide the S&B Straight Adapter (F) over
the MAF sensor’s honey comb end, secure
using a # 60 Hose Clamp (J).
19. Remove the protective covering from the
S&B Clear Lid (C).
13. Connect the MAF sensor assembly to
the S&B Filter Adapter ( I ) and secure using a
#60 Hose Clamp (J).
16. Place another # 60 hose clamp (J) on
the Hump Adapter (L) then insert the small
end of the S&B Tube (M) into the S&B Hump
Adapter. Then position the other end of the
tube over the throttle body and firmly secure
the # 72 Hose Clamp (N), then secure the #
60 Hose Clamp (J) at the Hump Adapter.
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5042 / 75-5042D
17. Install the Crankcase Vent Hose (Q) onto
the S&B Intake Tube (M) vent port and then
onto the engine port where the OE line was
removed in step #4 . Secure with two # 4
Hose Clamps (P).
18.Place the S&B Air Filter (D) into the S&B
Air Box (G), rotate the filter about a 1/4 turn
for clearance and slide onto the flange and
secure the # 80 Hose Clamp (E).
20. Place the Clear Lid (C) on the Air Box
(G) and secure using the 8/32 SS Screws (A)
and SS Washers (B).
21. Reconnect the MAF sensor electrical
connection.