User's Manual

8 S&C Form 974
Connect to a TripSaver II Controller Module
Step 3
Obtain Transceiver ID
A Transceiver ID unique to each TripSaver II Controller
Module is needed to establish communications between
your computer and the device. See Figure 6. The ID consists
of a 32-digit character string in the format of
“0019C900.00020000. _ _ _ _ _ _ _ _ . _ _ _ _ _ _ _ _”.
You must enter the ID in order to communicate with each
TripSaver II Controller Module.
The Transceiver ID is also labelled on the top of the
controller module side attached to each TripSaver II
Controller Module when it leaves S&C Electric Company.
Step 4
Connect to Device
To connect to a TripSaver II Controller Module, select
Connection>Connect to Device from the main menu
or click the Connect to Device icon
in the quick access
toolbar. Make sure that the USB transceiver is already
plugged into your computer.
Next, a Transceiver ID Request dialog box will appear.
See Figure 7. Enter the Transceiver ID of the TripSaver II
Controller Module you want to connect to, and click on
the OK button to connect. The first 16 digits of the ID are
pre-typed. You only need to enter the last 16 digits.
During the connection process, a status bar will be
displayed. Wait about ten seconds for the connection
process to finish, or click the Cancel button to cancel the
connection process.
You will be able to see the Status Screen after your
TripSaver II Controller Module is successfully connected.
Now, you can view existing settings, status information, and
event logs of the TripSaver II Controller Module, or apply
new settings to the device.
Enter last 16 digits here
Figure 6. The transceiver ID.
Figure 7. Enter the tranceiver ID number.