User's Guide

8 S&C Instruction Sheet 461-512LD
Software
Figure 5. Setting a static IP address on a PC to connect to
the gateway controller.
Figure 6. A ping response in the MSDOS command
window.
Logging in to a TripSaver II Gateway
Controller
Complete the following steps to log in to the controller:
STEP 1. The communication gateway software is stored
onboard the gateway controller and is accessed
using a Web-browser interface. The default
conguration of the gateway controller’s IP
gateway is 192.168.1.1 with DHCP set as “On.” To
join the gateway controller’s network, set the
PC’s network address to “Obtain an IP Address
Automatically” and “Obtain DNS Server Address
Automatically” under the PC’s LAN address
settings to enable a network connection to the
gateway controller. Alternately, a static IP
address within the 192.168.1.x network may be
used.
STEP 2. Allow approximately 5 minutes for the
communication gateway to boot. Conrm the
PC has successfully joined the communication
gateway network by launching an MSDOS
command prompt and issuing a ping 192.168.1.1 -t
command. A MSDOS ping “Reply” message will
display, conrming the connection between the
PC and communication gateway is active.