User's Guide

S&C Instruction Sheet 461-512LD 7
Hardware
Antenna Specifications
The gateway controller is professionally installed
equipment. The radio frequency (RF) output power does
not exceed the maximum limit allowed in the country of
operation.
CAUTION
Unauthorized antenna, modifications, or attachments
may damage the gateway controller, violate
regulations, or cause minor injury.
Note: Use only the supplied or an equivalent replace-
ment antenna.
Note: Any modification to the controller or use of an
unauthorized antenna not expressly approved by S&C
Electric Company is the sole responsibility of the user,
configurator, or operator. Any modification or use of
an unauthorized antenna must reassess the equipment
in accordance with all applicable international safety,
EMC, and RF standards. Authorized antennas are listed
as follows:
Mobile Broadband (SMA male):
Frequency Type Avg. Gain (dBi) Peak Gain (dBi)
2200 – 2483 1.5 4
GPS: Monopole (SMA male):
Frequency Type Avg. Gain (dBi) Peak Gain (dBi)
1571 - 1578 28 -
1601 – 1603 28 -
Connecting to the Gateway Controller
Complete the following steps to connect to the gateway
controller:
STEP 1. Connect the four-pin ac power cable to the
gateway controller. Plug in the gateway
controller to a 120-Vac outlet.
STEP 2. Connect an Ethernet cable to Ethernet 1 on the
gateway controller. Connect the other end to the
Ethernet port on a personal computer (PC).
Note: The gateway controller will take between 5 and 15
minutes to fully boot. After powering the gateway con-
troller, wait at least five minutes before trying to log in
to the controller.
Figure 4. Connecting the gateway controller to ac power
and Ethernet 1 port.