Safety Instructions
S&C Instruction Sheet 1076-510 3
Introduction
This device complies with Part 15 of the FCC radio-frequency rules. Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Industry Canada Statement
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject
to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appar-
eils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage;
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment should be installed and operated with a mini-
mum distance of 20 centimeters (7.9 inches) between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune
autre antenne ou émetteur.
Cet équipement devrait être installé et actionné avec une distance minimum de 20
centimètres entre le radiateur et votre corps.
Industry Canada Radiation Exposure Statement
This device meets the exemption from the routine evaluation limits in section 2.5 of
RSS102 and users can obtain Canadian information on radio-frequency exposure and
compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section
2.5 de RSS 102 et la conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir
l’information canadienne sur l’exposition et la conformité de rf.
NOTICE
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTICE
Changes or modifications not expressly approved by S&C Electric Company could
void the user’s authority to operate the equipment.
Warranty
The standard warranty contained in S&C’s standard conditions of sale, as set forth in
Price Sheet 150, applies to S&C SpeedNet Cell Edge Gateways.
Warranty
Qualifications
Warranty of the SpeedNet Cell Edge Gateway is contingent upon the installation,
conguration, and use of the SpeedNet Cell Edge Gateway and software in accordance
with S&C’s applicable instruction sheets. This warranty does not apply to major
components not of S&C manufacture, such as batteries, and other communication
devices not of S&C manufacture. However, S&C will assign to immediate purchaser or
end user all manufacturers’ warranties that apply to such major components.