User Manual

• Apply. Saves changes made to the configuration of the System Tab. Changes will not be saved
if you change to a different configuration tab without first pressing the apply button.
• Reboot. Pressing the Reboot button will cause the SpeedNet Radio to reboot.
Firmware Tab
The Firmware Tab is used to upgrade the firmware that is installed on the SpeedNet Radio. The following
parameters can be configured:
• File. Use the Browse button to specify the location of the firmware file to be uploaded.
• Upgrade. After selecting the firmware file, press the Upgrade button to initiate the firmware
upgrade. The SpeedNet Radio will reboot at the conclusion of the upgrade. Note: the radio
should not be disturbed during the firmware upgrade process.
If a SpeedNet Radio loses power during the firmware upgrade process, the radio will continue to use the
version of firmware that was installed prior to the attempted firmware upgrade.
Shell Tab
The Shell Tab is provided to support advanced integrator troubleshooting and does not play a role in the
configuration of a SpeedNet Radio network.
Statistics Page
The Statistics Page contains several tabs that provide statistical information regarding interface traffic,
protocol data, and routing. This section contains descriptions of each statistic that is available through
the SpeedNet Radio Client Tool.
Ethernet Tab
The Ethernet Tab provides the following statistical information regarding performance of the SpeedNet
Radio’s Ethernet interface.
• Bytes received. Total number of bytes received by the SpeedNet Radio’s Ethernet interface.
The bytes received, together with the bytes sent, represent the total data transfer of all
communications links involving the Ethernet interface.