User Manual

ionTig 200 Pulse PFC

Observe that whether the display value of LED is intact. If the display number is not

intact, please replace the damaged LED. If it still doesn’t work, please maintain or

replace the display PCB.

Observe that whether the min/max value on LED accords with the set value. If there is

any difference and it has affected the normal welding craft, please adjust it.

Checkup that Whether fan is damaged and is normal to rotate or control. If the fan is

damaged, please change immediately. If the fan does not rotate after the arc welding

machine is overheated , observe that whether there is something blocked in the blade, if

it is blocked, please get rid of ; If the fan does not rotate after getting rid of the above

problems, you can poke the blade by the rotation direction of fan. If the fan rotates

normally, the start capacity should be replaced; If not, change the fan.

Observe that whether the fast connector is loose or overheated. If the arc welding

machine has the above problems, it should be fastened or changed.

Observe that Whether the current output cable is damaged. If it is damaged, it should

be wrapped up, insulated or changed.

Monthly

examinatio

Using the dry compressed air to clear the inside of arc welding machine. Especially

for clearing up the dusts on radiator, main voltage transformer, inductance, IGBT

module, the fast recover diode and PCB, etc.

Check up the bolt in arc welding machine, if it is loose, please screw down it. If it is

skid, please replace. If it is rusty, please erase rust on bolt to ensure it works well.

Quarter-

yearly

examinatio

Whether the actual current accords with the displaying value. If they does not accord,

they should be regulated. The actual current value can be measured by the adjusted

plier-type ampere meter.

Yearly

examinatio

Measure the insulating impedance among the main circuit, PCB and case, if it below

1MΩ, insulation is thought to be damaged and need to change, and need to change or

strengthen insulation.

5.2 Troubleshooting

 Before arc welding machines are dispatched from the factory, they have already been debugged

accurately. So forbid anyone who is not authorized by us to do any change to the equipment!