User Manual

ionTig 200 Pulse PFC
Copyright © Mundaka Welding & Gases, Inc.
18
Unit S
Setting range 0—10
Factory setting
Ic Crater arc current (only with 4T)
Unit S
Setting range 5—100% of main current Iw ；
Factory setting
Tpo Gas post-flow time
Unit S
Setting range 0.0—10.0
Factory setting
(3) Rod electrode (MMA) welding parameter
Parameter Setting range
Arc force 0-10
Hot start 0-10
(4) Power/Alarm indicator
Light up if the welder overheat.
(5) Welding current and other parameter display
Before start of welding Indicate the open-circuit voltage when you push the enconder for 3s and the display
shows the pre-set value of Tpr ,Is ,Tup,Iw,Dcy,Iw,Fp,Ib,Tdown,Ic,Tpo . After the start of welding, display
shows the present actual value of the welding current.
The control panel indicates which position has been reached in the welding process by brightening the light.