User Manual

ionTig 200 Pulse PFC

the right position. When the machine gets to the destination, it needs to be fixed up to avoid gliding.

When using forklift, its arm length must be long enough to reach the outside so as to ensure lifting

safely.

The movement may result in the potential danger or substantive hazard, so please make sure

that the machine is on the safe position before using it.

3.4 Power supply input connection

ionTig 200 Pulse PFC welding machines’ power supply connects to 220V.

When the power supply voltage is over the safe work voltage, there are over voltage and under

voltage protection inside the welder, the alarm light will on, at the same time, the current output will

be cut off.

If the power supply voltage continually goes beyond the safe work voltage range, it will shorten the

welder life-span. The below measures can be used:

 Change the power supply input net. Such as, connect the welder with the stable power supply

voltage of distributor;

 Induce the machines using power supply in the same time;

 Set the voltage stabilization device in the front of power cable input.

3.5 Polarity Connection (MMA)

MMA (DC): Choosing the connection of DCEN or DCEP according to the different electrodes.

Please refer to the electrode manual.

WTL

workpiec

electrode

DC POSITIVE

CONNECTION

Welding holder

TP-315

WTL