User Manual

ionMig 200 PFC
Copyright © Mundaka Welding & Gases, Inc.
22
4.2.3 MMA mode operation:
1. Press the weld manner key, choose MMA manner and the MMA LED is lighted；
2. Adjust the current knob to control the welding current；
3. Adjust the welding arc force knob to control the arc force current.
Note：The current display is preset current before welding and is welding current when welding. The
voltage display is real voltage.
4.3Welding parameters
Wire diameter (mm)
Welding current (A)
Plate thickness (mm)
0.6
25-110
1.0-1.6
0.8
35-160(200)
1.0-2.3
0.9
45-160(200)
1.0-2.3
1.0
45-160(200)
1.2-6
4 .4 Operation environment
▲ Height above sea level ≤1000 M
▲ Operation temperature range -10～+40℃.
▲ Air relative humidity is below 90 %( 20℃).
▲ Preferable site the machine some angles above the floor level, the maximum angle does
not exceed 15℃.
▲ Protect the machine against heavy rain or in hot circumstance against direct sunshine.
▲ The content of dust, acid, corrosive gas in the surrounding air or substance cannot exceed