User Manual

ionMig 200 PFC

1. Choose welding mode key: On TIG or MIG, Pressing the key can choose 2T or 4T welding mode.

2. Choose welding method key: Pressing the key can choose three function, MMA/TIG/MIG.

3. Welding current knob: Set the welding current.

4. Current display: Welding Current display when machine is working, Set current display before

welding. Unit：A.

5. Current LED： When the current LED is on, it display the actual output welding current(MIG).

6. Wire speed LED： You can use current setting knob to set the wire speed when the wire speed

LED is on (MIG).

7. Voltage display: Welding voltage display when machine is working, Set voltage display when MIG

mode before welding. Unit：V.

8. Welding voltage/Down slope/Arc force knob: On MIG, when the program voltage can’t perfectly

match the welding current, the knob can adjust voltage On TIG, the knob can adjust the current

down time. On MMA, the knob can adjust the force current.

9. Power Led: Power led is lighted when open the machine.

10. Alarm Led: When the welder is over voltage, less voltage, over current or over heated, the alarm

pilot lamp will be on.

11. Wave control knob: Controls arc characteristics, Determines the rate at which the amperage rises

when a short circuit is produced.

12. TIG GAS Connect

13. MIG GUN Connect.

14. Output cathode：When MIG mode, this polarity must connect the work piece

15. TIG gun control connecter.