Installation Manual

888-825-3432 www.S-5.com

Attach almost anything to exposed-fastened roof systems,

with no messy sealants and no chance for leaks!

Tools Needed

• ElectricScrewgun

• Rag



VersaBracket should be placed in the flat of the panel,

between the ribs, and must be mounted directly over and

into the supporting structure of the roof, i.e. wood decking, wood or steel purlins

or trusses, NEVER into the metal roofing material alone.

To ensure brackets are installed in a straight line, install a single VersaBracket on each

end of the roof at a measured, consistent distance from the bottom edge of the roof. Use

a string line between the two brackets. Mount the remaining VersaBracket along the string

line, directly into the supporting structure of the roof.

To install VersaBracket:

1) Determine the location of the supporting structure of the roof. When possible, secure

the VersaBracket using all hole locations; when not possible, always use the two

up‑slope hole locations.

2) The only surface preparation necessary is to simply wipe away excess oil and debris.

3) Peel the release paper from the base, align and apply to roof surface.

4) Secure the VersaBracket directly into the supporting structure of the roof by drilling screws

into the pre‑punched holes directly into the supporting structure of the roof (3 holes are

provided for convenience and versatility). Consult the S‑5! Load Table for more information.

Installation Instructions

S-5!® Warning! Please use these products responsibly!

Has the installation of VersaBracket™ been properly spaced and

configured and the proper screws selected for your specific roof

application? If not, see our Calculator and Load Table at

www.S-5.com or ask your distributor.

Notice to S-5! users: specific layout and assembly schematics

for S‑5! products are the responsibility of the user or project

designer. Due to the many variables involved with specific panel

products, climates, snow melt phenomena and job particulars,

the manufacturer cannot and does not express any opinions

as to the suitability of any S-5! assembly for any specific

application and assumes no liability with respect thereto. S‑5!

clamps are tested for ultimate holding strength on various seam

types and materials. This information is available from the S‑5!

website: www.S‑5.com. This document is an installation guide

only and the photographs and drawings herein are for the

purpose of illustrating installation tools and techniques, not

system designs.

VersaBracket™ Install

version 101310

S‑5! products are patent protected. S‑5! aggressively protects its patents, trademarks and copyrights.