Specifications

Please note: All measurements are rounded to
WKHVHFRQGGHFLPDOSODFH
Distributed by
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. Visit the website at www.S-5.com for
complete information on patents and trademarks. For maximum holding strength, setscrews should
be tensioned and re-tensioned as the seam material compresses. Clamp setscrew tension should be
verified using a calibrated torque wrench between 160 and 180 inch pounds when used on 22ga steel,
and between 130 and 150 inch pounds for all other metals and thinner gauges of steel. Consult the S-5!
website at www.S-5.com for published data regarding holding strength.
Copyright 2012, Metal Roof Innovations, Ltd. S-5! products are patented protected.
S-5! aggressively protects its patents, trademarks and copyrights. Version 102212.
7KHVWUHQJWKRIWKH66FODPS LVLQLWVVLPSOHGHVLJQ7KHSDWHQWHG
setscrews will slightly dimple the metal seam material but not pierce it—
OHDYLQJURRIZDUUDQWLHVLQWDFW
S-5-S Mini Clamp
S-5-S Clamp

PP

PP
0KROHV
from either edge

PP

PP
0[PPEROW

PP

PP

PP
M8 hole centered
on part

PP

PP
0[PPEROW

PP
VHWVFUHZ[
([DPSOH3UR¿OHV

The S-5-S and S-5-S Mini clamps are each furnished with
the hardware shown to the right. Each box also includes
a bit tip for tightening setscrews using an electric screw
gun. A structural aluminum attachment clamp, the S-5-S
is compatible with most common metal roofing materials
excluding copper. All included hardware is stainless
steel. Please visit www.S-5.com for more information
including CAD details, metallurgical compatibilities and
specifications.
The S-5-S clamp has been tested for load-to-failure
results on most major brands and profiles of standing
seam roofing. The independent lab test data found at
www.S-5.com can be used for load-critical designs and
applications. S-5!® holding strength is unmatched in the
industry. Profiles that are shaped as illustrated below will
work with the S-5-S and S-5-S Mini. In order for the S-5-S
or S-5-S Mini to fit these types of seams, the finished seam
must:
t Be at least 1.00” high.
t Have a height distance less than or equal to 0.25”
between the male portion of the panel and female
portion of the panel.