Datasheet

Distributed by
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. Visit the website at www.S-5.com for
complete information on patents and trademarks. For maximum holding strength, setscrews should
be tensioned and re-tensioned as the seam material compresses. Clamp setscrew tension should be
veried using a calibrated torque wrench between 160 and 180 inch pounds when used on 22ga steel,
and between 130 and 150 inch pounds for all other metals and thinner gauges of steel. Consult the S-5!
website at www.S-5.com for published data regarding holding strength.
Copyright 2015, Metal Roof Innovations, Ltd. S-5! products are patent protected.
S-5! aggressively protects its patents, trademarks, and copyrights. Version 031915.
The strength of the S-5-E clamp is in its simple design. The patented
setscrews will slightly dimple the metal seam material but will not
puncture it—leaving roof warranties intact.
S-5-E Mini Clamp
S-5-E Clamp
Please note: All measurements are rounded to the second decimal place.
The S-5-E and S-5-E Mini clamps are each furnished
with the hardware shown to the right. Each box also
includes a bit tip for tightening setscrews using an
electric screw gun. A structural aluminum attachment
clamp, the S-5-E is compatible with most common
metal roong materials excluding copper. All included
hardware is stainless steel. Please visit www.S-5.com for
more information including CAD details, metallurgical
compatibilities and specications.
The S-5-E and S-5-E Mini clamps have been tested for
load-to-failure results on a variety of double-folded
standing seam roofs, from leading manufacturers of
panels and panel-forming machines. The independent lab
test reports found on our website at www.S-5.com prove
that S-5!® holding strength is unmatched in the industry.
Hardware shown is included with each clamp.
Example Proles
For horizontal seams under
.5", crimp the seam to 180
degrees at desired clamp
location.
This illustration demonstrates
crimping technique, NOT actual
location of clamp.
≤ .5"
Hardware shown is included with each clamp.
1.18"
(30.00 mm)
0.98"
(25.00 mm)
1.97"
(50.00 mm)
0.60"
(15.00 mm)
(2x) M8-1.25
Threaded Hole
M8-1.25
Threaded Hole
1.18"
(30.00 mm)
0.98"
(25.00 mm)
1.18"
(30.00 mm)
0.30"
(7.60 mm)
0.35"
(8.90 mm)
0.30"
(7.60 mm)
0.35"
(8.90 mm)
0.60"
(15.00 mm)
M8-1.25 X 16 mm
Hex Flange Bolt
M8-1.25 X 16 mm
Hex Flange Bolt
Two 3/8-24 X 0.80"
Round-Point
Setscrews
Four 3/8-24 X 0.80"
Round-Point
Setscrews