Installation Guide

To Install RibBracket
™
Mini
1. The only surface preparation necessary is to simply wipe away excess oil
and debris.
2.
driving the included fasteners into the pre-punched holes, or pre-drilling
the proper-sized hole through the pre-punched holes and riveting with
bulb-type rivets (as per rivet manufacturers installation instructions).
Drive the fastener in until it is tight and the washer is firmly seated. Do
not over-drive fasteners; a slight extrusion of rubber around the washer
is a good visual-tightness check. If a fastener has been over-driven, it is
important to remove the fastener and replace it with a bulb rivet or
larger diameter fastener. To avoid stripping, use screw gun with depth-
sensing nose piece or adjustable torque clutch.
3.
From either end of the RibBracket Mini, slide the included M8-1.25 hex
flange nut (flange side up) into the top groove. The RibBracket Mini is
now ready to install the S-5-PV Kit by insertion of the the PV stud, or
other ancillaries by using a standard M8 bolt through the slotted top
thru-hole and the previously inserted hex flange nut. For critical
attachment applications utilizing an M8-1.25 X 16 mm Hex Flange Bolt,
tighten the M8 bolt to 160 inch pounds (13 foot pounds).
RibBracket
™
Mini Installation Instructions
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. For published data regarding holding strength, fastener torque, patents and trademarks, visit the S-5! website at www.S-5.com.
Copyright 2014, Metal Roof Innovations, Ltd. S-5! products are patent protected.
S-5! aggressively protects its patents, trademarks, and copyrights. Version 092614.
RBI-V1.0-0915