Installation Guide

version 101310

Installation Instructions

S-5!® Warning! Please use these products responsibly!

Has the installation of CorruBracket™ been properly spaced and

configured and the proper screws selected for your specific roof

application? If not, see our Calculator and Load Table at

www.S-5.com or ask your distributor.

Notice to S-5! users: specific layout and assembly schematics

for S‑5! products are the responsibility of the user or project

designer. Due to the many variables involved with specific panel

products, climates, snow melt phenomena and job particulars,

the manufacturer cannot and does not express any opinions

as to the suitability of any S-5! assembly for any specific

application and assumes no liability with respect thereto.

S‑5! clamps are tested for ultimate holding strength on various

seam types and materials. This information is available from the

S‑5! website: www.S‑5.com. This document is an installation

guide only and the photographs and drawings herein are for the

purpose of illustrating installation tools and techniques, not

system designs.

Tools Needed

• ElectricScrewgun

• Rag

CorruBracket must be mounted directly over and into the supporting structure of the roof, i.e.

wood decking, wood or steel purlins or trusses, NEVER into the metal roofing material alone.

To ensure brackets are installed in a straight line, install a single CorruBracket on each

end of the roof at a measured, consistent distance from the bottom edge of the roof. Use

a string line between the two brackets. Mount the remaining CorruBracket along the string

line, directly into the supporting structure of the roof.

To install CorruBracket:

1) Determine the location of the supporting structure of the roof. When possible, secure

the CorruBracket using all hole locations; when not possible, always use the two up‑slope

hole locations.

2) The only surface preparation necessary is to simply wipe away excess oil and debris.

3) Peel the release paper from both bases, align and apply to the clean area.

4) Secure the CorruBracket directly into the supporting structure of the roof by drilling

appropriate screws into the pre‑punched holes and into the supporting structure.

S‑5! products are patent protected. S‑5! aggressively protects its patents, trademarks and copyrights.

CorruBracket™ Install

888-825-3432 www.S-5.com

Attach almost anything to corrugated metal roong, with no

messy sealants and no chance for leaks!