CorruBracket 100T Brochure

ManualsBrandsS-5! ManualsRacking & MountsCorruBracket 100T Mini for Corrugated Roofs

The right way to attach almost anything to metal roofs!

CorruBracket

™

100T (and Mini)

888-825-3432 | www.S-5.com |

CorruBracket

™

100T

CorruBracket™ 100T is designed specically for

corrugated roong proles that are common

in North America. CorruBracket 100T is

axed to the crest of the corrugation, leaving

the drainage plane free of holes to protect

against leaks. For medium‑duty applications,

the bracket can be attached directly to the

sheeting, accommodating ancillary attachment

anywhere along the corrugation. For heavy‑duty

applications, the bracket can be xed into the

underlying substrate for additional support

without crushing the corrugation.

Having no messy sealants to apply, CorruBracket

100T comes with a factory‑applied EPDM

rubber gasket seal already on the base, and the

S‑5!®‑patented reservoir conceals the EPDM from

UV exposure, preventing UV degradation.

Installation is simple! CorruBracket 100T

is mounted directly into the crest of the

corrugation, straddling the valley. No surface

preparation is necessary; simply wipe away excess

oil and debris, align, and apply. Secure directly

into the crest of the corrugation by driving the

appropriate screws into the pre‑punched holes,

or pre‑drilling the proper‑sized hole through the

pre‑punched holes and riveting.

The slotted top hole, which accommodates

standard M8 nuts and bolts, simplies alignment

and maximizes exibility in attaching ancillaries.

CorruBracket

™

100T Mini

The CorruBracket™ 100T Mini is a bit shorter

than its standard counterpart and has two

pre‑punched holes in its base rather than four.

The mini is the choice for attaching all kinds of

rooftop accessories: signs, walkways, satellite

dishes, antennas, rooftop lighting, lightning

protection systems, solar arrays, exhaust stack

bracing, conduit, condensate lines, mechanical

equipment—just about anything!*

S-5!® CorruBracket

™

100T is the right way to

attach almost anything

to corrugated roong

proles common in North

America, including PV via

rail or DirectAttached™

methods.

*S‑5! mini brackets are not compatible with, and should not be used with, S‑5!

SnoRail™/SnoFence™, or ColorGard®, or X‑Gard™ snow retention systems.

Summary of content (2 pages)

PAGE 1
CorruBracket™ 100T is designed specifically for corrugated roofing profiles that are common in North America. CorruBracket 100T is affixed to the crest of the corrugation, leaving the drainage plane free of holes to protect against leaks. For medium‑duty applications, the bracket can be attached directly to the sheeting, accommodating ancillary attachment anywhere along the corrugation.
PAGE 2
CorruBracket™ 100T can be used for almost any attachment need on corrugated metal roofing commonly found in North America. The CorruBracket™ 100T and CorruBracket™ 100T Mini each come with factory‑applied EPDM rubber gaskets on the base. A structural aluminum attachment bracket, CorruBracket 100T is compatible with most common metal roofing materials. For design assistance, ask your distributor, or visit www.S‑5.