Use and Care Manual

9 — English
OPERATION
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 10 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
ACCESSORIES
Look for these accessories at the service center:
Round Sub-base .............................................................................................................................................519233001
Edge Guide Assembly ......................................................................................................................................204358001
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or
accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recom-
mended can result in serious personal injury.
USING EDGE GUIDE (NOT INCLUDED)
See Figures 12 - 13, page 12.
Use the edge guide to trim or cut a straight or curved edge.
 Remove the battery pack.
 Thread guide bars into the base and tighten with a flat
head screwdriver.
 Slide the edge guide onto the guide bars.
 Install thumb screws provided into the edge guide.
 Measure the proper distance to offset the bit, or if trim-
ming, position the bit at the edge of the workpiece.
 Tighten the two thumb screws to secure the edge guide.
 Reinstall the battery pack.
 Move the router along the workpiece keeping the edge
guide in constant contact with edge of the workpiece.