Specifications

English
4
To remove:
Depress the latches on both sides of the battery pack
to release and remove the battery pack.
DIGITAL DISPLAY
See Figure 4.
The digital display on the front of the radio illuminates when
the radio is switched on, displaying the time or frequency,
and mode. If the battery charge is low, a fl ashing low
battery indicator will also be displayed:
/
NOTE: Charge battery when low battery indicator begins
to fl ash. If the radio continues to operate with the low
battery indicator fl ashing, the radio will drain the battery
until the radio no longer emits sound. To avoid deep
discharge, remove the battery pack from the radio and
charge immediately.
TURNING THE RADIO ON/OFF
See Figure 4.
Press the on/off button to turn the radio on or off.
NOTE: When the radio is off, the time will be shown on the
display even if the 18 V battery is removed after the AAA
batteries have been installed.
ADJUSTING THE VOLUME
See Figure 4.
When the radio is turned on, it will return to the last volume
setting used.
NOTE: If the 18 V battery is removed from the radio or
has no charge, the radio will return to the default volume
setting.
To increase the volume: Push the VOLUME UP button.
To decrease the volume: Push the VOLUME DOWN
button.
NOTE: To change volume quickly, hold the VOLUME UP
or VOLUME DOWN button.
MODE SELECTION
See Figure 4.
To switch modes, press the mode button. The selected
mode will be shown in the digital display. There are three
modes:
 FM mode
 MW mode
 AUX mode
NOTE: When turned on, the radio will return to the last
mode that was used unless the 18 V battery is removed
or has no charge.
MANUAL TUNING
See Figure 4.
The TUNE/SEEK buttons are used to manually tune to
the desired radio frequency. The selected frequency is
displayed on the digital display.
To use tune feature:
 Press the TUNE/SEEK DOWN button and quickly
release to tune to the next lowest frequency step.
 Press the TUNE/SEEK UP button and quickly release
to tune to the next highest frequency step.
To use seek feature:
 Press and hold TUNE/SEEK DOWN button for one
second to tune to the next lowest frequency with clear
reception.
 Press and hold TUNE/SEEK UP button for one
second to tune to the next highest frequency with clear
reception.
To use the antenna:
Raise or lower radio antenna until radio channel can
be heard clearly.
STORING A PRESET IN MEMORY
See Figure 4.
The memory feature saves up to 20 frequencies as presets
in the radio’s memory. You can save 10 frequencies in FM
mode and 10 in MW mode.
To store a frequency in memory:
 Tune to the frequency you want to save.
 Press and hold the PRESET button. A memory
location number will blink on and off.
 Press the TUNE/SEEK UP or TUNE/SEEK DOWN
button to select a memory location.
 Press the PRESET button to store the frequency in the
selected memory location.
To recall a preset frequency:
 Press the PRESET button and quickly release to cycle
through stored frequencies.
SETTING THE CLOCK
See Figure 5.
Press the CLOCK button to view the time in the digital
display. To return to the frequency view, press the CLOCK
button again.
NOTE: In AUX mode, the time is always displayed.