Specifications
Avolites Rolacue Operators Manual - page 86
rq96man 19/09/1996 18:30
• Turn Key to Program.
Puts you in Live Program Mode.
• Save your Show on a blank disk. Label it ! See Section 13.1.3 Saving
your show to disk.
• Turn the Key to System.
Puts you in System Mode.
• Press Softbutton A [SERVICE].
Puts you in the Service menu.
• Press Softbutton A [RUN AVOS 2].
• Type in the Password 68340 and press ENTER.
Puts you in the AVOS menu.
• Press Softbutton E [SAVE PROGRAM] and insert a blank disk.
• Press ENTER to Save your old System Software
. Not only does this back your
System Software up, but it double checks that the disk drive writes properly before you
dump the System!
• Press Softbutton D [VERIFY] to check the Save.
Not only does this check
your save, but it double checks that the disk drive reads properly before you dump the
System Software. If the Save or Verify was bad, try Saving and Verifying another disk. If
still unsuccessful, consult Avolites before proceeding.
• Assuming a successful save, remove the disk and label it OLD
SOFTWARE. WRITE PROTECT IT!
• IF Option 3 ERASE ALL SEGMENTS is available, select it and run it.
Follow any on screen prompts which may be given.
• After running Option 3, or if Option 3 is not available, inset the new
System Software disk and press Softbutton B [BURN A NEW
PROGRAM] followed by ENTER.
This loads the new System Software.
• Once the System Software is loaded, press any key to exit the menu.
Puts
you back in the AVOS menu.
• Press Softbutton A [Start the System].
Desk starts up.
• After running AVOS you must do a WIPEALL. See Section 1.6.1 To do
a WIPEALL.
• Reload your Show from the disk made earlier in the usual way. See
Section 13.1.5 Loading a show from disk.
13.6 Loading a new AVOS operating system
You will need :
A blank disk.
The Disk containing the new AVOS operating system.
The file name for this is RAM.PRL.
⇒ Do not attempt this unless the mains supply is stable. If the desk is
turned off during programming new flash Memory will be required
from Avolites!
• Turn Key to Program.
Puts you in Live Program Mode.
• Save your Show on a blank disk. Label it ! See Section 13.1.3 Saving
your show to disk.
• Turn the Key to System.
Puts you in System Mode.
• Press Softbutton A [SERVICE].
Puts you in the Service menu.