Specifications

Avolites Rolacue Operators Manual - page 84
rq96man 19/09/1996 18:30
13.4.1 Fitting the WIPEALL link on the SAPPHIRE
• Turn Key to Program. Puts you in Live Program Mode.
• Save your Show on a blank disk. See Section 13.1.3 Saving your show
to disk.
• Switch off the desk and unplug it.
To avoid damage to desk or technician.
• Undo the three Dzus fasteners at the back of the desk which secure the
card frame door and open this giving access to the various circuit boards.
• Locate the MAP circuit board.
This board is longer than the other boards.
• On the edge of the board locate a link connector marked SW1. This is
below the LED on the same edge of the board.
• Move the jumper link header (coloured blue) to connect to both
terminals of SW1.
The normal position of this will be on one terminal. If the link header has been lost
you can carefully connect the terminals with a piece of fuse wire.
There is no need to remove the card.
• Plug in and power up the desk. The LCD Screen should now display the AVOS II
menu.
• Press Softbutton A [Start The System]. Do NOT select any other option.
• Power down the desk and unplug it.
• Remove the link. Replace this as it was found.
Do not forget to remove the link
or the desk will always power up in AVOS!
• Close the card frame door and refasten the Dzus fasteners.
• Plug in and power up the desk.
• Reload your Show from the disk you made earlier in the usual way. See
Section 13.1.5 Loading a show from disk.
13.4.2 Fitting a WIPEALL link on the Pearl
• Turn Key to Program. Puts you in Live Program Mode.
• Save your Show on a blank disk. See Section 13.1.3 Saving your show
to disk.
• Switch off the desk and unplug it.
To avoid damage to desk or technician.
• Undo the Dzus fasteners holding the top panel to the case and open the
desk
. Plugging in the desk lamp makes it easier to open the desk.
• Locate the WIPEALL Link. This is on the main processor board (The
largest PCB) near the main processor which is a large black chip.
• Move the blue jumper link header to connect both terminals.
• Plug in and power up the desk
. The LCD Screen should now display the AVOS II
menu.
• Assuming it powers up correctly, press Softbutton A [Start The System].
Do NOT select any other option.
• Power down the desk and unplug it.
• Remove the link. Replace this as it was found.
Do not forget to remove the link
or the desk will always power up in AVOS!