Specifications

Avolites Rolacue Operators Manual - page 79
rq96man 19/09/1996 18:30
This mode still has access to HTP Channels however.
In this mode you have access to Channels 1 to 30 on the Pearl and 1 to 60
on the Sapphire on both sets of Preset Faders.
Preset Bank A is controlled by the Preset Master Fader A.
Preset Bank B is controlled by the Memory Master Fader B.
There is therefore no Memory Master when running in Two Preset
mode.
Each Preset Channel has an ADD and a SWOP button associated with it.
The Preset SWOP function works to SOLO a Preset Fader, killing all other
Channels.
The Preset ADD button adds the Channel to the output of the desk.
In this Mode, the level to which Channels are put onto the output by the ADD
and SWOP buttons is controlled by the ADD and SWOP Master Faders.
In Two Preset mode, the Playback Area behaves the same as Normal Run
Mode, and Memories and Chases programmed using Dimmers or Fixtures on
Preset Channels 31 - 60 on the Pearl or 61 - 120 on the Sapphire will run as
normal, even though these Channels are not available on the Preset Faders.
See Section 12.3 The ADD and SWOP buttons in different Run Modes for
Playback ADD and SWOP button functions. The LED’s on the Playback
SWOP buttons follow the Playback Fader Level.
When you turn the Key back to Program, the Preset Faders work in Wide
mode again.
Overall levels are governed by the Grand Master.
⇒ If you wish to record a scene set up in Run mode, make sure the scene is
created on Preset Bank A.
⇒ You can patch Dimmer Channels onto Channels 1 - 30 on the Pearl and
1 - 60 on the Sapphire and Intelligent Fixtures onto Channels 31 - 60 on
the Pearl (61 - 120 on the Sapphire) as normal. You can then run your
show in Two Preset Mode giving access to the Dimmer Channels on both
Preset Banks, and recalling Intelligent Fixtures from programmed
Memories and Chases.
12.3 The ADD and SWOP buttons in different Run Modes
This is a Table showing how the SWOP and ADD buttons work in the
different run modes.
Preset Playback
Run Mode
Preset ADD Preset SWOP Playback
ADD
Playback
SWOP
Normal Run
Adds that
channel onto
the output
Solos that
channel onto
the output
See
Appendix 5.
Functions of
the ADD
Solos the
Memory or
Chase onto
the output.