Specifications

Avolites Rolacue Operators Manual - page 78
rq96man 19/09/1996 18:30
Each Preset Bank can control up to 60 HTP Channels on the Preset Faders
(120 on the Sapphire). The level at which they are output is controlled by
Preset Master A.
Channels 1 - 30 (1 - 60 on the Sapphire) also each have a Preset SWOP and
a Preset ADD button associated with them.
The Preset SWOP function works to Solo a Preset Fader, killing all other
Channels.
The Preset ADD button adds the Channel to the output of the desk.
In this Mode, the level to which Channels are put onto the output by the ADD
and SWOP buttons is controlled by the ADD and SWOP Master Faders.
Playback Fader levels are controlled by the Memory Master Fader B.
See Section 12.3 The ADD and SWOP buttons in different Run Modes for
Playback ADD and SWOP button functions. The LED’s on the Playback
SWOP buttons follow the Playback Fader Level.
Overall levels are governed by the Grand Master.
12.1.2 Takeover Run mode
When you switch from Program to Takeover Run mode, the Programmer
does not clear and you have access to all HTP and LTP Channels. You can
use Wheels or Preset Faders to control Attributes exactly like Program
mode. The only difference is that HTP Preset Channels are under the control
of Preset Master A.
The Preset ADD and Preset SWOP buttons have the same functionality as
they do in Program mode, so you can still Select lamps with the SWOP
buttons, apply Preset Focuses from the ADD buttons, Slave Channels, etc.
Use CLEAR to clear the Programmer as normal.
⇒ In Takeover mode you can recall Preset Focuses over a given time by
selecting Fixtures, typing a time on the Keypad and than selecting the
Preset Focus button. (Do not press ENTER after keying in the time). This
is a very useful feature when ‘busking’ a show.
Playback Fader levels work normally and are controlled by the Memory
Master Fader B.
See Section 12.3 The ADD and SWOP buttons in different Run Modes for
Playback ADD and SWOP button functions. The LED’s on the Playback
SWOP buttons follow the Playback Fader Level.
Playback SWOP buttons do not work at all.
You should note however that the response time of the Playback ADD buttons is
slower than the Normal Run Mode response time. (The average time for these
buttons in Normal Run Mode is 85mS and in Takeover Run Mode is 185 mS).
Overall levels are governed by the Grand Master.
12.2 Running in Two Preset Mode
In Two Preset mode when you switch the Key from Program to Run, the
Programmer is cleared and you no longer have access to any LTP
Channels.