Specifications

Avolites Rolacue Operators Manual - page 6
rq96man 19/09/1996 18:30
⇒ To avoid storing unwanted information when programming press the
CLEAR button before starting to build any Memories or Chases.
If a channel does not change in level when a Playback Fader is moved it
is probably under the control of the Programmer. Release it by pressing
CLEAR.
See also Section 4.2 How HTP and LTP Channels behave in the
Programmer.
1.5.1 Placing Channels in the Programmer
Channels are placed in the Programmer when ever they are edited by any
means but not as a result of recalling Memories or Chases.
Recalling a Memory or a Chase on a Playback Fader does not put the
Channels in the Programmer.
⇒ This means that you cannot record new Memories or Chases using looks
straight from a Playback Fader (However see Section 6.12 Using
INCLUDE to program a Memory).
1.5.2 Clearing Channels from the Programmer
Channels can be removed from the Programmer by :
• Either Pressing CLEAR
or holding down the blue OFF button and pressing the Preset ADD or
Preset SWOP button associated with the Channel (See Section 4.10 The
OFF button).
1.6 Clearing the Desk with a WIPEALL
A WIPEALL empties the Rolacue of all previous programming, including the
patch, but leaves the System Software intact.
⇒ A WIPEALL is recommended before starting to program any new show.
Make sure any important data is saved to disk before doing a WIPEALL
or it will be lost forever!! (See Section 13.1.3 Saving your show to disk.)
1.6.1 To do a WIPEALL
• Turn the Key to System. Puts you in SYSTEM MODE menu.
• Press Softbutton A [SERVICE].
Puts you in the SERVICE menu.
• Press Softbutton F [WIPEALL].
Puts you in the Confirm WIPEALL menu.
• Press Softbutton A [EXECUTE WIPEALL].
Console energises and restores
you to SYSTEM MODE menu.
• Turn Key to Program.
Puts you in LIVE PROGRAM MODE menu.
• Start programming!!