Specifications

Avolites Rolacue Operators Manual - page 70
rq96man 19/09/1996 18:30
9.6 Programming in BLIND mode
9.6.1 Entering Blind Mode
• Turn the Key to Program. Puts you in LIVE PROGRAM MODE menu.
• Press Softbutton F [PRESS FOR BLIND MODE].
Puts you in BLIND
PROGRAM MODE menu.
When in Blind Mode the Programmer and the Preset Faders are
disconnected from the output so you can build or edit Memories and Chases
without your programming being seen on stage.
Programming is identical to Live Program Mode except your changes cannot
be seen on the output.
⇒ When you enter Blind Mode, Channels already in the Programmer stay
there. It may therefore be desirable to CLEAR the programmer on first
entering Blind Mode, or Channels in the Programmer may be included in
your programming.
9.6.2 Exiting Blind Mode
• Again press Softbutton F [PRESS FOR LIVE MODE] Puts you in LIVE
PROGRAM MODE menu.
When you exit Blind Mode Channels in the Programmer are cleared and the
programmer is reloaded with any Channels that were in the programmer
before Blind Mode was selected.
This means that entering and exiting Blind Mode does not affect what is seen
on stage, and you can Blind Program in the middle of a show if necessary.
⇒ To keep the Programmer contents before you return to Live mode you
should record a Memory, which you can later INCLUDE. See Section 6.12
Using INCLUDE to program a Memory.
9.6.3 To alter a Memory without the look on stage
• Turn the Key to Program. Puts you in LIVE PROGRAM MODE menu.
• Press Softbutton F [PRESS FOR BLIND MODE].
Puts you in BLIND
PROGRAM MODE menu.
• Include the Memory to be altered.(See Section 6.12 Using INCLUDE to
program a Memory.)
• Edit the Memory as required.
• Save the Memory in the usual way.
• Take down the Preset Faders and press CLEAR.
• Again press Softbutton F [PRESS FOR LIVE MODE].
Puts you in LIVE
PROGRAM MODE menu.
If the Memory Playback Fader is up then take it down and put it back up to
load the new Memory.