Specifications

Avolites Rolacue Operators Manual - page 68
rq96man 19/09/1996 18:30
9.2.10 Screen 10 - PAGE PLAYBACK STATUS
This displays the status of each Playback Channel. This is useful if you are
using times on Memories or Chases since you can see them fading in and
out. It is also useful if you are using Script Files. See the Section 16 The
Script File System.
9.2.11 Screen 11 - SCRIPT FILE
See Section 16 The Script File System for further details.-
9.2.12 Screen 12 - VIEW PATCH BY HANDLE
This Screen is split into two sections.
The upper section gives the handle number, Fixture name and DMX
address.
The lower part of the Screen gives information on how to set the various
switched and controls on the Fixture itself.
This is displayed one Fixture at a time and the Up and Down cursor buttons
are used to select the Fixture from the list on the upper part of the Screen.
There are some Fixtures which when patched, may not show up on the lower
part of this Screen.
In order for this Screen to work, the Fixture must have a channel patched onto one of
the Preset Faders on Preset Bank 1. Generally this will be the case, however there
are some instances when this will not happen.
Some examples are:- A pan and tilt yoke, some colour mix devices which use three
Channels on the colour banks but no Dimmer.
⇒ This Screen has a large processing overhead and should not be viewed
during time critical operations, or during a show unless absolutely
necessary.
9.2.13 Screen 13 - GRAPHICS TABLET INFORMATION
The Screen is split into two halves.
The lower half of the Screen gives the Attribute names and their numeric
location on the Preset Bank.
The upper half of the Screen is for the display of Tables such as colours etc.
See Chapter 14 The Graphics Tablet for details.
9.2.14 Screen 14 - CHASE UNFOLD
When you UNFOLD a Chase, Screen 14 is automatically loaded, and it tells
you which Playback Faders have got Chase Steps on them, and whether the
steps are Simple (denoted by ‘s’) or Complex (denoted by ‘c’).
9.3 Programming Groups
Groups can be quickly created allowing simple selection of a number of
Fixtures.
To record a Group :