Specifications
Avolites Rolacue Operators Manual - page 58
rq96man 19/09/1996 18:30
FADER STOPS, GO TO START does not start the Chase until the GO button
is pressed after the Playback Fader is moved up.
7.29.6 Softbutton B - WAIT AND FADE ALL STEPS / SKIP FIRST WAIT TIME / SKIP
FIRST WAIT AND FADE TIME
These options control how the first step of the Chase is run.
WAIT AND FADE ALL STEPS uses the times exactly as programmed.
SKIP FIRST WAIT TIME removes the first Wait time so starts the Fade as
soon as the Playback Fader is moved up.
SKIP FIRST WAIT AND FADE TIME places the first step on the output as
soon as the Playback Fader is moved up. Think of this option as removing all
the first step’s times.
7.29.7 Softbutton C - MANUAL MODE ALLOWED / DISALLOWED
When manual mode is allowed Wheel A can be used to manually fade the
step.
The Wheel output is fed into the Timer input, thus if a long time has been
programmed into the step, more turns of the Wheel will be required to Fade
into the step.
If a short time has been programmed into the step only a small number of
turns will be required. This allows you to customise how the Wheel will control
the Fade.
⇒ If manual mode is disallowed the Wheel cannot be used to control the
fade.
7.29.8 Softbutton D - SPEED WHEEL ALLOWED / DISALLOWED
This option allows or disallows the Speed Wheel.
7.30 Previewing a Chase Step
To see the output of a Chase Step in Program or Run mode :
• Press the VIEW button.
• Press the SWOP button of the Chase you want to VIEW
. The Playback Fader
does not have to be up
.
If a Chase Fader is down, you will VIEW step 1 of the Chase.
• You can step through the Preset Banks and see the desk outputs for
each Attribute for the VIEWED Chase Step.
Press EXIT to quit.
7.31 Previewing Chase Times
Screen 7 shows the Chase times for the Connected Chase. See Section
9.1.2 To VIEW a Memory or Chase.
⇒ In some cases it may be useful to make a COPY of a Chase allowing
previewing and editing of steps of a Chase whilst running the same on
another playback. This also allows you to easily jump to a step out of
sequence by setting the second Fader to a different step and manually
fading between the two.