Specifications

Avolites Rolacue Operators Manual - page 49
rq96man 19/09/1996 18:30
7.10.6 LTP Wait time
This is the amount of time that elapses when a Step starts before an LTP
Fade starts.
7.10.7 Link ON or OFF
Linked Chase steps automatically run on one from the next. If you Unlink any
steps, the Chase will stop at the Unlinked Step, and you have to press the
Playback ADD button or the GO button to restart the Chase.
You must have the Chase Connected to restart it using the GO button.
7.10.8 Entering a Fade or Wait time
You can enter different times for each timer using its Softbutton.
Softbutton A [WAIT IN]
Softbutton B [WAIT OUT]
Softbutton C [FADE IN]
Softbutton D [FADE OUT]
Softbutton E [LTP FADE]
Softbutton F [LTP WAIT]
Softbutton G [LINK = ON / OFF]
Under each Softbutton label on the Screen is the time for that Timer.
The time can range from tenths of a second to 12 hours.
• Set each time by entering the time on the Keypad and pressing the
appropriate Softbutton. Use the decimal point to separate hours,
minutes, seconds and fractions of a second.
For example
To set a time of 45 minutes :
Press 4 5 . . then the Softbutton requiring the time.
To set a time of 1 minute 10 seconds :
Press 1 . . 1 0 then the Softbutton [ A - F]
To set a time of half a second (0.5 seconds) :
Press . 5 then the Softbutton [ A - F]
• Press ENTER to record the Times.
7.11 Using the ADD and SWOP buttons when replaying a Chase
The effects vary considerably depending on how you have the desk
configured, and which Run mode you are using. See Chapter 12 Running
your show for more details.
7.12 Editing Global Chase Times
7.12.1 Editing Global Chase Times using the Wheels
Connecting a Chase and using the Wheel(s) in the normal way applies
Global times to a Chase.