Specifications

Avolites Rolacue Operators Manual - page 44
rq96man 19/09/1996 18:30
Typically this can be used to reduce the level of all the HTP Channels in a
particular Memory. The Playback Fader for that Memory is put up at the
correct level, and the output recorded back into the Memory itself at the new
level.
Another use is for this function is to incorporate one Memory into another
existing Memory, at the level that is being output.
• Turn the Key to Program.
Puts you in LIVE PROGRAM MODE menu.
• Set up the stage look you wish to record.
• Press the blue MEMORY button on the Program Select bank.
Its LED will
light up
.
• Press Softbutton A [PRESS TO RECORD STAGE].
• Re-store the Memory you are Editing in the usual way.
⇒ Remember the edits recorded into a Memory are not made active on that
playback until the Memory Fader is taken down and raised again, in some
cases it may be useful to lower and raise the playback before pressing
clear, therefore making the edits active.
6.14 Recording and recalling Memories on the Graphics Tablet and Stage
Remote
Memories can be recorded directly from the Graphics Tablet. See Section
14.9.3 Record Memory in the Graphics Tablet chapter.
Memories can replayed directly from the Stage Remote. See Section 15.4
Using the Remote to recall a Memory in the Stage Remote chapter.
6.15 Help and Hints
Problem : Memory does not replay after programming.
Solution : Press the CLEAR button, or turn the Key to Run.
Problem : Programmed Memories have disappeared.
Solution : Check that you are on the correct Roller Page.
Problem : Some HTP Channels do not replay.
Solution : Check that they have not been reduced in the Reduction bank.
See Section 9.5 Reduction Faders.
Problem : Some Channels on Moving Lights do not replay.
Solution : They probably have not been recorded. If you are using Record
by CHANNEL then you must edit each channel that is to be recorded to put it
in the Programmer. This means that you must access each one and do
something to it, even if it is only reasserting the level it is currently at. See
Section 6.1 Recording Modes.
Problem : The Presets, Wheel and Tablet do not output to the stage.
Playbacks work correctly.
Solution : Check you have not selected BLIND mode. See Section 9.6
Programming in BLIND mode.