Instruction manual

The asterisk ( * ) indicates that there are currently no steps in the show being programmed. To select

a chase to add to the show, press the button next to P1-C to step through the chase pages (1-8) and

select a chase by using the scanner selection keys 1-16. Available chases will be shown by dimly lit

lights above the scanner selection keys. The currently selected chase will be indicated by a brightly lit

light above the fixture keys. The selected chase page is indicated after the ‘P’ on the display, the

chase number within the page is shown after the ‘C’. The selected chase will begin running allowing

a visual check that the required chase has been selected. To add the chase to the show select Add; the

selected chase will be added at the end of the show and the step number will be adjusted accordingly.

Repeat the selecting and adding process for the number of desired steps. To see which chases have

been used in the show, use the keys to increase or decrease the step number and view the chase

making up the selected step. If you wish to delete a step, select the step to remove and select Del.

When you are happy with all the steps of the show select Quit to return to the show menu. To preview

the programmed show select Run, the programmed show will start running.

If you need to delete a step or add steps to your show then select PGM from the show menu but

without holding the button down, this will allow alteration of the steps forming the show. After any

changes have been made you may return to the show menu by selecting Quit and preview the show by

selecting Run as before.

To save the show select Store, the display will change to show:

This is the prompt asking which show store is to be used to hold the show. If there are any shows

already programmed they will be shown by the lights above the scanner selection keys being dimly lit.

At this point it should be noted that already programmed shows can be overwritten or deleted without

any warning being given. To save the show , select a show store by pressing one of the scanner

selection keys 1 - 16. The show will be saved and a message informing you that the save has been

completed will be given, you will then be returned to the show menu. You may then program and

save more show in the same way as described above. To delete a stored show the procedure is the

same as for storing a show except that that you should press and hold the scanner selection key of the

show you wish to delete for about 1 second, after which the show will be deleted.

Changing a previously stored show

To make changes to a previously stored show select Show from the main menu. This will take you to

the show menu:

Select the show to change by using the scanner selection keys 1 - 16 (available shows are shown by

dimly lit lights above the scanner selection keys). The selected show will now start to run. Select

PGM but without holding the button down. You may now alter the which chases make up the show.

When the show has been changed to your liking it can be re-saved to the same show store or a

different show store as described above. As and aid to replacment, the last show recalled will be

indicated by a brightly lit light above the scanner selection keys when you are prompted for the show

to store to. A show can be copied by recalling the show and then re-saving it to a different show store.

Selecting Stop from the show menu will stop a running show, allowing the current fixture state to be

saved as another scene if desired.