Operation Manual

UNLOAD pELLET
Fire the pellet at a safe target to
unload the gun. If this is not practical,
cock the gun to open the barrel and
push the pellet from the chamber by
running a cleaning rod through the
muzzle end. Insert a felt cleaning
pellet and discharge into a safe target.
TRIGGER DEvICE
The pistol is manufactured with an adjustable trigger. To adjust the trigger,
hold the pistol by the compression tube, grip upwards, insert a screw
driver through the hole in the trigger guard and loosen the set screw (A).
Now the sleeve (B) for the adjustable trigger can be turned (See Fig. 6)
–Turning clockwise = greater pull
–Turning counterclockwise = lesser pull
The double pull can be eliminated if the sleeve is turned counterclockwise
until there is no more resistance in the trigger.
If the pull is turned too far clockwise then the trigger is locked. After
adjusting the trigger, tighten set screw (A) again.
The screw inside the sleeve (C) is for adjusting the trigger pull weight —
–Turning clockwise = higher resistance
–Turning counterclockwise = less resistance
WARNING: AIR pISTOLS ARE A SpECIAL CLASS OF
NON-pOWDER GUNS AND bECAUSE OF THEIR DESIGN, MAY HAvE
TRIGGERS WHICH CAN bE ADjUSTED TO bELOW 3 LbS pULL
AND COULD FIRE IF DROppED.
CAUTION: Check the tightness of the front trigger guard and
grip screws between, during and after shooting activity. Loose
screws may cause injury or death.
SIGHT ADjUSTMENT
The RWS Air Pistol is equipped with TruGlo®
ber optic sights. If the pistol shoots low, turn
the screw (D) counterclockwise (“UP”) (See
Fig. 7). If the pistol shoots high, turn the
screw (E) clockwise (“R” = Right).
Fig. 6
B
A
C
Fig. 7
D
E
STORAGE
NEVER STORE A LOADED OR COCKED GUN. Unload pellet from the
pistol. Keep pistol away from children and untrained shooters. Store
pellets separately from the pistol to keep them from untrained shooters.
Protect your pistol from moisture and dirt; clean gun and wrap it in a
smooth, dry cloth, or store the gun in its original packaging. If you are
going to store your airgun for an extended length of time be sure the
barrel is protected. This can be accomplished by coating the bore with
a good acid-free and resin-free oil or grease. Always use a soft brush
and insert the cleaning rod from the breech end on break barrel pistols.
Remove the oil/grease completely before the next use.
MODIFICATION
CAUTION: The components of this gun were engineered and
manufactured to deliver optimum performance. Any modication or
tampering with a gun may cause a malfunction, void your warranty
and may make it unsafe to use. Any change in performance (such as
a lowered trigger pull force and shortened trigger travel) indicates
possible modication, tampering and/or wear. Such gun should be
inspected, replaced or properly repaired by only qualied RWS /
Umarex USA personnel. Any gun that has been dropped should be
checked by qualied personnel to ensure that its function has not
been affected.
WARNING: A GUN THAT IS NOT OpERATING pROpERLY
MAY bE DANGEROUS. IT SHOULD bE kEpT SAFELY FROM USE
bY ANYONE UNTIL REpAIRED OR DESTROYED. DO NOT TRY TO
TAkE THE GUN ApART. IT IS DIFFICULT TO REASSEMbLE AND
IMpROpER DISASSEMbLY OR REASSEMbLY CAN CAUSE SERIOUS
INjURY OR DEATH.
AMMUNITION
Your RWS air pistol is designed to re caliber .177 lead pellets only.
We recommend the use of RWS Pellets because of their superb accuracy
and dimensional uniformity. The correct caliber is clearly stamped on the
barrel near the breech block or on the breech block.
CAUTION: Do not attempt to reuse red pellets or pellets which
are deformed. Projectiles such as steel shot (BBs) and darts may
damage your air pistol and cause injury to you or bystanders due to
ricocheting.