Operation Manual
Fig. 5
PINCH
POINT
PINCH
POINT
PINCH
POINT
OpERATING INSTRUCTIONS
STEp 1. pRIOR TO OpERATION
WARNING: bE SURE THE GUN IS ALWAYS pOINTED IN A
SAFE DIRECTION. NEvER pOINT THE GUN AT ANYONE EvEN IF IT
IS UNCOCkED AND UNLOADED. ALWAYS ASSUME AND HANDLE
THE GUN AS IF IT WERE LOADED AND READY TO FIRE.
STEp 2. COCk
WARNING: WHEN COCkING THE pISTOL DO NOT pLACE
YOUR HAND OvER OR IN FRONT OF THE MUzzLE. DON’T
ALLOW THE MUzzLE TO pOINT TOWARD YOU OR ANYONE ELSE
DURING COCkING. ALWAYS kEEp THE MUzzLE pOINTED IN A
SAFE DIRECTION.
With one hand grasp grip
rmly, avoiding contact with the
trigger. Grasp the barrel just
behind the front sight. Pull the
barrel all the way down and
under the air pistol until you
reach the end of the cocking
stroke. You will hear a click
indicating that the spring piston has been locked into position (See Fig.
3a). Cocking automatically engages the safety.
STEp 3. LOAD
Insert the correct caliber lead pellet carefully
into the chamber of the breech end which
is now exposed (See Fig 4a). Be sure to
seat the pellet ush with the breech. Avoid
damaging the pellet skirt.
STEp 4. CLOSE bARREL / LEvER
Firmly grasp the barrel behind the front sight, return the barrel to its
original closed and latched position.
CAUTION: Be careful to keep ngers clear of cocking
mechanism. (See “Pinch Points”, Fig. 5) Grasp the barrel or lever
rmly as you cock it and close it to prevent
it from snapping back and possibly causing
injury.
STEp 5. AIM AT A SAFE TARGET
CAUTION: Your backstop should be
inspected for wear before and after each
use. Discontinue use if the backstop surface
shows signs of failure. Always place the
backstop in a location that will be safe should the backstop fail.
Discontinue the use of a backstop if the projectile rebounds or
ricochets.
STEp 6. pUT “OFF SAFE”
Push the safety switch to upward position (See Fig. 2b).
STEp 7. FIRE
Pull the trigger.
WARNING: IF A pELLET DOES NOT FIRE AFTER COMpLETING
THE OpERATION STEpS, THE GUN MAY bE jAMMED. AN UNFIRED
pROjECTILE IN THE bARREL CAN bE A DANGEROUS SITUATION.
kEEp GUN pOINTED IN A SAFE DIRECTION AND REpEAT ALL
OpERATION STEpS ExCEpT STEp 3. IF A pROjECTILE STILL DOES
NOT FIRE, DO THE FOLLOWING:
1. Cock the gun and leave the barrel open. The safety will automaticaly
engage in the “ON SAFE” position.
2. Clear barrel by running a cleaning rod through from muzzle end.
3. Repeat operation steps.
SAFETY “ON” SAFETY “OFF”
Fig. 2bFig. 2a
Fig. 3a
COCK
LEAD PELLET
(Solid End Forward)
Fig. 4a