Installation Manual

INSTALL A T ION(INSTR U C T IO N S (
8848 Instructions 12-18-14.docx Page 2 of 5
Step 4: Remove spare tire and slide (3) supplied Push
Nuts on the studs.
Step 5: Reinstall spare tire.
Install Chassis Harness
Step 6: Insert connector from Camera connector
through the rear gate vent behind tire carrier.
Step 7: Using a plastic trim removal tool, remove
interior panels on inside of rear gate.
Step 8: Pull harness through the rear gate openings.
Step 9: Use supplied Wire Ties to secure Chassis
Harness to existing harness.
Step 10: Use supplied Wire Ties to secure Chassis
Harness to existing harness.
Step 11: Use supplied Wire Ties to secure Chassis
Harness to fabric factory wire cover. CAUTION: Leave
enough slack to allow gate to open fully.