Instruction Manual
Reverse With Condence ™
9
INSTALLATION
RCA Installation
Remove the spare tire and attach the camera to the spare tire carrier.
Run the cable through the rear vent to the inside of the car. Remove the
two plastic covers on tailgate to receive the camera cable.
Remove the panels on the passenger side rear cargo area. Connect ca-
ble you ran through the tailgate to the red/yellow adaptor and then to
the long yellow cable. Remove panels and run the yellow cable along
the carpet closest to the rear/front door. Run the yellow cable to the
kick panel lower level left passenger side.
The next step is removing the head unit. There will be 4 screws on the
head unit that need to be removed.
Note: You will need to purchase an ALPINE- ALP-HRN-CAMCH CAMERA
INPUT HARNESS to complete this install.
Plug this input harness into the back of compatible radios (2007-up)
430ren-430rbz-430n-rhb-730n-rer-730n-rhr Chrysler factory head
units. Once plugged run the video cable down to the kick panel and
connect the video cable that you just ran from the rear camera (With
this install you do not need to connect the red wires on both ends of
the RCA video cable just tape them).