Operating Instructions

5
 Installation of other parts
1. Find the right place for camera mounting. e.g.: Drill a hole to install the embedded style
camera.
2. Find a proper place in the cab to mount the monitor.
3. Master and extension controller should be placed in a clean and dry place.
6. Connection
1. Please pay attention to the custom wire harness for connection between the ultrasonic sensor
kit and the back-up system. Make sure that reverse trigger wire from the harness is connected
to the reverse light or is hardwired to power if the camera monitor is already wired accordingly.
2. Connect the 5PIN FEMALE jack to the Monitor and 5PIN MALE plug for camera.
3. The master controller should be hooked by the custom wire harness for VIDEO IN & VIDEO
OUT. The port (Data Link) on the bottom-right of the master controller is connected to the
bottom-left port (Data Link) of the extension controller via the 461-10 Data Link cable.
4. The sensor input cables should be plugged in sequence.
5. The controllers and camera are both powered by the monitor, which is powered by the vehicle
battery.
6. Notice: *Leave the input cables from the sensors unconnected for testing.