Installation Manual
Table Of Contents
- Introduction
- SSV9 Kit Contents
- Making SSV9 Connections
- Recommended SSV9 Camera Locations and Settings
- SSV9 Electrical Tapping Points Reference Guide
- SSV9 System Configuration
- System Setup Menus
- SSV9 User Management
- System Information, Disk and File Management
- Playing Back Videos
RVS-96D Installation and Setup Guide
COPYRIGHT © 2017 Rear View Safety
52
1.
2.
3.
4.
a.
The Motion Detection menu enables you to set motion detection properties for each of the
six channels, which are selectable from the channel pull-down menu.
After you select a channel from the menu, you can apply properties for that channel as
described in the following steps.
Enable Status: use the check box to enable and disable motion detection.
Select the alarm delay (in seconds) by pressing in the field and using the numeric keypad.
press when done.Enter
Alarm delay is the length of time the alarm channel displays in full-screen mode and with a
recorder.
Set detection region(s) for the channel: