Installation Manual
Table Of Contents
- Introduction
- SSV9 Kit Contents
- Making SSV9 Connections
- Recommended SSV9 Camera Locations and Settings
- SSV9 Electrical Tapping Points Reference Guide
- SSV9 System Configuration
- System Setup Menus
- SSV9 User Management
- System Information, Disk and File Management
- Playing Back Videos
RVS-96D Installation and Setup Guide
38
1.
2.
3.
1.
2.
Lift signal tap points
Peterbilt
The white wire on the camera harness is usually connected to a proximity switch on the arm
assembly.
White wire (1753 212) in a large bundled harness near the rear of the cab, leading to the
joystick.
2015 Scorpion trucks have a white wire underneath the joystick that has a programmable
output signal and can be triggered off any of the proximity switches on the arm.
Labrie Arms
The majority of Labrie systems have a wire labelled 235i inside the PTO box associated with
a proximity switch on the arm when it is elevated.
Other possiilities include wires labelled ‘Auto-cam switcher’ and ‘Arm Mid Position’.
Zero Radius – Autocar 2014
Behind an access panel located on the body, driver side, near the front, are a series of fuse
assemblies. A part of assembly 1483835, there is a green wire labelled ‘Arm up stowed prox’
associated with the proximity switch on the arm when stowed all the way up.
RVS-96D System Configuration
COPYRIGHT © 2017 Rear View Safety