Installation Manual
Table Of Contents
- Introduction
- SSV9 Kit Contents
- Making SSV9 Connections
- Recommended SSV9 Camera Locations and Settings
- SSV9 Electrical Tapping Points Reference Guide
- SSV9 System Configuration
- System Setup Menus
- SSV9 User Management
- System Information, Disk and File Management
- Playing Back Videos
RVS-96D Installation and Setup Guide
COPYRIGHT © 2017 Rear View Safety
22
Quick Links - Sample Vehicle Installations
Mack - MRU
Mack - MR
Mack - LEU600
Mack - CT713
Autocar
Peterbilt
International - 7600
Freightliner - M2 12yd Minimax 2014
CCC
Sterling - Condor
American - LaFrance
Electrical Requirements
12v
The 12v tap must be after the battery disconnect (i.e., turning battery disconnect off eliminates 12v
to the Fleetmind mobile platform. Turning battery disconnect on reapplies 12v). Other names for
the battery disconnect are night switch and kill switch.
Ground
Most trucks have a dedicated ground stud while some trucks require locating the screw that is
tapped into the chassis as ground. Note that a clean ground implies direct contact to a rust free
metal surface.
Reverse & Brake
For both reverse and brake, the Fleetmind mobile platform is expecting a state change from 0v
(disengaged/off) to 12v (engaged/on).