Installation Manual
Table Of Contents
- Introduction
- SSV9 Kit Contents
- Making SSV9 Connections
- Recommended SSV9 Camera Locations and Settings
- SSV9 Electrical Tapping Points Reference Guide
- SSV9 System Configuration
- System Setup Menus
- SSV9 User Management
- System Information, Disk and File Management
- Playing Back Videos
RVS-96D Installation and Setup Guide
17
2
Reverse. Color back-up guides superimposed on view.
3
Left turn signal. Delayed cancellation of image display/record.
4
Right turn signal. Delayed cancellation of image display/record.
Camera Trigger Connections
Camera trigger wires must be connected to the vehicle's outputs.
Ensure that cameras with special associated trigger signals (i.e., Reverse, Left Turn, Right Turn)
are connected to the output terminals receiving the appropriate vehicle input signals to the terminal
block.
Power Connection
The 12V tap must be after the battery disconnect (i.e., turning battery disconnect off eliminates
12V to the mobile platform. Turning battery disconnect on reapplies 12V). Other names for the
battery disconnect are night switch and kill switch.
See RVS-96D Electrical Tapping Points Reference Guide.
Power should NOT be connected to the vehicle's ignition key switch.
Recommended RVS-96D Camera Locations
COPYRIGHT © 2017 Rear View Safety