Instruction Manual

REAR VIEW SAFETY
Troubleshooting
Monitor Displays Blue Screen & Displays No Signal
• Do a hard reset, leave out for
1 minute and then re-connect
them.
• Check
to ensure that the con-
nection to the camera is tight.
• Verify camera cable is plugged
into port labeled Backup
Camera
• Verify that the blue positive
trigger on power harness is
put to power 12v+.
If the problem still persists, ver-
ify that alternate ports work. If
alternate ports do not work, re-
move Blue Trigger wire from
12V+ and select alternate chan-
nels.
Monitor Will Not Power-Up (no backlight on power button)
• Check fuse
• Check 12v+ to monitor
• Check ground connection
No Image On Screen
• Verify camera is in correct
camera input
• Verify cable is connected to
monitor
• Verify camera is connected to
cable
• Connect known working
camera and cable to monitor.
• Verify Blue trigger is receiving
power
Audio on Camera (optional)
• Verify chosen camera has
audio
• Verify volume setting
• Confirm that the Blue audio
trigger is connected to 12v+
19