Instruction Manual

- 47 -
1.6.1.1 PTZ CAMERA SETUP
The 1.6.1.1 PTZ CAMERA screen allows up to four PTZ (Pan, Tilt, Zoom) Cameras to be programmed,
viewed and controlled by the MDVR using its IR Remote Control (IRC) or a compatible PTZ Joystick
Control Console.
Read the manual supplied by the PTZ Cameras manufacturer.
Set the operational codes on the camera as required. Then enter the same codes in the MDVR using the PTZ
Camera screen. Ex.: Pelco D (Protocol), 2400 (Baud), 1 (Data Bit), 1 (Stop Bit), NONE (Check).
The ADDR can be from 1 – 255 and must be unique for each device.
Enter the first PTZ Camera settings. Save the settings, then select SUMMARY to view 1.6.1.1.1 PTZ
CAMERA SUMMARY page for a display of the current settings of PTZ Cameras installed on the MDVR.
Add other PTZ Cameras in the same manner by selecting another device using the DEVICE field.
CHANNEL
Select one of four channels for the PTZ Camera to use:
CH 1-4
PROTOCOL
Select from two industry standard PTZ operating codes:
PELCO D
PELCO P
BAUD
Select to match the settings on the PTZ Camera
DATA BIT
Select to match the settings on the PTZ Camera
STOP BIT
Select to match the settings on the PTZ Camera
CHECK
Select to match the settings on the PTZ Camera
ADDR
Enter to match the settings on the PTZ Camera. Each PTZ Camera must have a
different address
Action Bar Keys (Select, then press ENTER):
SUMMARY
To move to the 1.6.1.1.1 PTZ CAMERA SUMMARY PAGE
MASTER MENU 1.6
'PERIPHERALS'
PERIPHERALS
SETUP 1.6.1
'PTZ CAMERA'
PTZ CAMERA
1.6.1.1
Mobilemule™