Instruction Manual

- 42 -
1.4.6.1 MOTION DETECTION
The 1.4.6.1 MOTION DETECTION screen is the first of three screens necessary for the setup, activation
and testing of the motion detection features for each camera channel. Motion Detection based triggering
may only be used when the vehicle is parked or when the camera is in an enclosed area of the vehicle, as
changing lighting conditions may trigger the Motion Detection Zone.
Setup must be complete for all three screens to properly enable and test the motion detection function:
1.4.6.1 MOTION DETECTION SETUP
Setup and subsequently test each camera using the
motion detection function
1.4.6.1.1 MOTION DETECTION GRID
Setup the motion detection activation zone
1.4.5.1 ALARM OUT SETUP
Setup the motion detection response to trigger an
ALARM OUT and/or LOG the event.
ENABLE
Select from two options:
ON The selected functions are ‘On’
OFF The selected functions are ‘Off’
SENSITIVITY
Select from three levels:
LOW
MED
HIGH
AREA
Select the SETUP field. The 1.4.6.1.1 MOTION DETECTION screen will appear as
an overlay on the camera view. The SETUP button backgrounds are color coded to
display their status:
BLACK Motion Detection area has not been setup
GREEN Motion Detection Zone is ready to detect
YELLOW Motion Detection has been triggered
SETUP
When you select the Area ‘SETUP’ button the 1.4.6.1.1 MOTION DETECTION
GRID screen is displayed. Instruction and setup of the motion detection zone are on
the following page
Action Bar Keys (Select, then press ENTER):
SAVE
To save the Motion Detection Zone settings
ALARM OUT SETUP
To move to the 1.4.5.1 ALARM OUT SETUP screen and add a response
MASTER MENU 1.4
'ALARMS'
ALARMS 1.4.6
'MOTION'
MOTION
DETECTION 1.4.6.1
Mobilemule™